PREPARE

• First, prepare a suitable 9V DC center-negative power supply with at least 250 mA or higher. Daisy-chain power solutions are not recommended.
• Then, close any applications that may be using MIDI, such as DAWs or other MIDI controllers.
• And have a USB-C cable ready to connect your AUTO M-Type pedal to your computer.

CONNECT

• Connect your AUTO Series pedal to a suitable power supply while holding both footswitches.
• The dynamic LED bar will show a rolling animation, confirming that the pedal has entered firmware update mode.
• Use a USB-C cable to connect the AUTO Series pedal to your computer.
• Your computer’s operating system may (and may not, no worries about that) notify you that a new MIDI device - your AUTO Pedal - has been connected.
• And depending on your browser, check if any pop-ups are asking you to enable the MIDI sysex messages.
• You can find the full update instrucion in the README.pdf file.